CONVERTED TRANSPORTER 2.0 T6.1 (2020) Sleeps 4, Converted Nov 2023 (Diesel, Ulez Compliant)

Specification of conversion

·      ROOF: elevated roof – All bare edges
cleaned, each sealed with an acid etch primer and over coated with
a polyurethane body adhesive to prevent any future corrosion
issues. A full front, rear and side steel strengthening support frame
Installed.
3 x roof bed boards lined in
the same carpet lining as the side of the campervan. This enables
the campervan to sleep 4.

·       WINDOWS – N/S/F fixed window and an O/S/F Slide opening
window by the cooker and sink area, 2 x barn door window and one
n/s/r. These are black limo tinted windows (tint within the glass not the
lower standard film tinted windows)
As with the roof all cut bare edges
will be acid etch and PU sealed

·       INSULATION – The vehicle is fully insulated firstly with thermal foil
and then with plastic hollow fibre insulation (we never use rock wool as
it can rot and start to smell a few years down the line)
All internal channels in the vehicle side construction are fully
insulated otherwise massive heat loss can occur.

·       CARPET LINING – vehicle is fully carpet lined

·   FULL ELECTRICAL INSTALLATION-
standard T5 wiring loom installed in the vehicle, controlled by a full Power Management System PMS
3 (made by bonus systems).240v hook up point fitted.
1x twin 240v power point and 1x 12v power point inside the vehicle.
1x flexi LED strip light behind the driver’s seat (this can be used to
illuminate the roof space) and 3x LED down lights on the passenger side
and 2 x LED down lights on the drivers.
A 110amp high quality leisure
battery installed with a smart- com intelligent charging system
that charges when the engine is running (and the main vehicle battery is
fully charged) – so no chance of a flat battery in the morning!!
The leisure battery is also charged when hooked up to 240v on campsites via
the power management system. All wiring is carried out with automotive thin wall grade wire.

·       FLOOR COVERING- upgraded floor to 12mm (9mm floors are not sufficient) and covered with hard wearing Altro
floor covering in a choice of colours. All edges finished in alloy
covering trims.

·        FULL INSIDE CONVERSION-
kitchen unit with 2 cutlery compartments and a large storage area, a smev combination sink and 2
burner hob unit, with over kitchen storage unit.
Wardrobe/ Cupboard
unit with front door and 2 x rear doors. All the furniture in this conversion is made from caravan/motorhome lightweight grade
ply. No heavy, easy to damage chip wood.

·       WAECO CR 50 COMPRESSOR FRIDGE- Top of the range compressor
fridge lasts 1-2 days on 1 charge.

·      SEALED GAS LOCKER – will be installed with a drop out vent in the floor –
so any gas will escape out (gas is heavier than air) Comes with GAS SAFE
cert.

·       TABLE – Table and sliding rail system. The table can be securely stowed
behind the driver’s seat when not in use using the clips provided.
The LWB model also has a freestanding table.

·      SEAT & BED SYSTEM (WITH EEC CERTIFICATE- EC DIRECTIVE
76/115/EECFOR M1 LOADING) – sliding seat and bed system with 2 x 3point seatbelts secured to the underside of the vehicle with a steel supporting frame.
The bed/seat is upholstered in a fabric to match in with the front seats, the bed/seat base will be boxed in to match the
side units with a rear access door.

The front twin passenger seat swivels.

·    VAN X CURTAINS – Top of the range curtains supplier in blackout black.